View 3D Load Config

marccrosby · #11 (**permalink**) February 9th, 2009, 21:49

Ive attached my container optimisation parameters for you to check...I know these work. Let me know if this helps

tangfj · #12 (**permalink**) February 9th, 2009, 22:29

Hey Marc, Thanks a lot for your doc. I'm going to try them out shortly. One quick quesiton. Are you on CU5? My instance is on CU5 and I'm wondering if my problems have anything to do with that.

vidya · #13 (**permalink**) March 6th, 2009, 10:12

Hi,

I'me experiencing the same issue, kindly share the screenshots??

thanks in advance

marccrosby · #14 (**permalink**) March 10th, 2009, 09:56

Ive attached the presentation i have on load config setup

sandeepdeore · #15 (**permalink**) March 17th, 2009, 09:29

Quote:

Originally Posted by marccrosby

Yep, we managed to get this working now...its actually not too difficult once you know what is mandatory. Im pretty busy at the moment but would be happy to give you a hand when i get some free time. Ive also got a powerpoint on 3d load config setup that might be useful

Hi Marc,

Can you please share the 3D Load config setup documents that your are refferring to? My mail id is sandeepdeore@yahoo.com

Thanks in Advance

Sandeep

marccrosby · #16 (**permalink**) March 17th, 2009, 09:37

The power point is attached to the thread now

Kiseleva · #17 (**permalink**) July 2nd, 2009, 08:16

Hi!
I have exactly the same problem as you discused - I get the error when try to view load confg: The loading configuration of Shipment Equipment 442 cannot be shown in 3D.

After I've tried all the set up that was advised here I think that there is some another secret

By the way - the table S_SHIP_UNIT_PIECE is empty.

Please share any ideas

vidya · #18 (**permalink**) July 3rd, 2009, 07:31

Hi,

Kindly check whether the weight and volume of the ship unit is calculated... their is a parameter AUTO CALC WEIGHT VOLUME set it true and try...

Kiseleva · #19 (**permalink**) July 3rd, 2009, 08:10

Thanks for reply!
I did it before, but it started to work only after Generate Ship Units. May be because OR was created manually...

pradeepsundar.v · #20 (**permalink**) July 6th, 2009, 13:52

Hi
I too faced a similar problem while trying to view load configuration for a multi stop scenario. A shipment was created only when Volume Estimation is used Load config engine type.

When Pattern based Optimize load config engine type was used, multi stop planning got timed out, and for other config engines types, planning failed.

Has there been any update on the load configuration?

Rgds
Pradeep